Akai DPS12 Manuale dell'Operatore Scaricare il pdf (Pagina 146)

134

Chapter 13: Using the effects

TRIGGER PAN (I)

This auto pan effect becomes enabled when the output level of AUX SEND A or AUX SEND B exceeds a certain

level. You can also press the [F6] key to start the auto pan effect manually.

Trigger

autopan

Parameter Setting range Function

1 Rate 0.1Hz – 10.0Hz Adjusts the speed of panning.

2 Mode Pan/L>R/R>L Sets the effect of panning. (Refer to AUTO PAN.)

3 Trigger AUX-A/AUX-B/MANUAL Selects signals that enable the auto pan effect (AUX SEND A or AUX

SEND B).

4 Thresh –60dB – 0dB Sets the signal level at which the auto pan becomes effective.

5 Width 0 – 127 Adjusts the panning width.

MONO DELAY (G)

This is a common delay effect.

Delay

Pan

Fdback

HFdamp

Parameter Setting range Function

1 Delay 1 – 1500ms Adjusts the delay time.

2 Fdback 0 – 127 Adjusts the amount of delay that is fed back.

3 HFdamp 20Hz – 20kHz Sets a frequency at which the higher range of the feedback sound is cut.

4 Pan L63 – MID – R63 Adjusts the stereo image of the effect sound.

PING PONG DELAY (G)

This delay effect pans the effect sound left and right.

Parameter Setting range Function

1 Delay 1 – 1500ms Adjusts the delay time.

2 Fdback 0 – 127 Adjusts the amount of delay that is fed back.

3 HFdamp 20Hz – 20kHz Sets a frequency at which the higher range of the feedback sound is cut.

4 Width 0 – 127 Adjusts the panning width.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 155 156

Nessun commento

Akai DPS12 Manuale dell'Operatore Pagina 146